Raymarine ST4000+ Owner's Handbook Manual page 65

81131_7.book Page 57 Wednesday, March 17, 2004 3:59 PM
Chapter 5: Installing the ST4000+
Pedestal socket mounting
If you need to raise the height of the drive unit mounting socket to
keep the tiller drive horizontal, use a Raymarine pedestal socket
assembly.
Identifying the correct pedestal socket
L
1. Clamp the tiller on the boat's center line.
2. Establish the standard control dimensions A and B.
3. With the tiller drive horizontal, measure dimension G.
4. Select the appropriate pedestal socket assembly from the table.
Dimension G
38 mm (1.5 in)
76 mm (3.0 in)
89 mm (3.5 in)
102 mm (4.0 in)
114 mm (4.5 in)
127 mm (5.0 in)
Mounting the pedestal socket
1. Mark the mounting ring's position on the cockpit seat or counter.
2. Ensure that control dimensions A and B are correct.
3. Mark the bolt holes on the mounting ring and then drill three
1
6 mm ( / in) diameter holes.
4
G
Pedestal socket length L
Standard dimension
38 mm (1.5 in)
50 mm (2.0 in)
64 mm (2.5 in)
76 mm (3.0 in)
89 mm (3.5 in)
57
D289-2
Part no.
-
D026
D027
D028
D029
D030