81131_7.book Page 75 Wednesday, March 17, 2004 3:59 PM
Chapter 6: Setting-up the ST4000+
Chapter 6: Setting-up the ST4000+
6.1 Functional test
Switch on
When you have installed the system, you need to check that the
system is wired correctly and set up to suit your type of boat.
This chapter provide instructions for the following post-installation
procedures:
Note: You can perform further customization after the sea trial, as
described in Chapter 7: Customizing the ST4000+.
1. When you have installed your ST4000+ autopilot system, switch
on the main power breaker.
2. If the control unit is active and the system operating, the control
unit will beep and display the pilot type (4000 WHL or 4000 TILL).
CAUTION: Wheel drive systems
One second after power-on the wheel pilot will drive to starboard
for three seconds. This is to allow even wear on the drive belt.
3. After displaying the pilot type for two seconds, the control unit
will then display the Standby screen.
Troubleshooting
•
If the head does not beep, check the fuse/circuit breaker.
If the display shows the SEATALK FAIL alarm message, check the
•
SeaTalk connections.
75
D3567-5