Front Right Bezel - HP ProLiant DL385 G7 Maintenance And Service Manual

Remove the hot-plug power supply.
4.
WARNING:
power cord to the power supply until the power supply is installed.
To replace the component:
Slide the hot-plug power supply into the power supply bay.
1.
Connect the power cord to the power supply.
2.
Install the cable management arm, if removed
3.
Route the power cord through the cable management arm or power cord anchor.
4.
NOTE:
the redundant power supply can be removed without disconnecting the power cord from the
primary power supply.
Close the cable management arm.
5.
Connect the power cord to the power source.
6.
Be sure that the power supply LED is green
7.
Display LEDs and health LED
Be sure that the front panel external health LED is green
8.

Front right bezel

To remove the component:
Extend or remove the server from the rack
1.
server from the
To reduce the risk of electric shock or damage to the equipment, do not connect the
If using the power cord anchor, be sure to leave enough slack in the power cord so that
combinations" on page 89,
rack" on page 27).
("Access the product rear
("Rear panel components" on page 84,
"Rear panel LEDs and
("Front panel LEDs and
("Remove the server from the
Removal and replacement procedures 32
panel" on page 28).
"Systems Insight
buttons" on page 85).
buttons" on page 83).
rack" on page 27, "Extend the