Hot-Plug Sas Hard Drive; Power Supply Blank - HP ProLiant DL385 G7 Maintenance And Service Manual

Hot-plug SAS hard drive

To remove the component:
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations
1.
SATA hard drive LED
Back up all server data on the hard drive.
2.
Remove the hard drive.
3.
To replace the component, reverse the removal procedure.

Power supply blank

To remove the component:
CAUTION:
all bays are populated with either a component or a blank.
Access the product rear panel (on page 28).
1.
Remove the power supply blank.
2.
WARNING:
power supply blank to cool before touching it.
For proper cooling do not operate the server without the access panel, baffles,
combinations" on page 91).
To prevent improper cooling and thermal damage, do not operate the server unless
To reduce the risk of personal injury from hot surfaces, allow the power supply or
Removal and replacement procedures 30
("SAS and