Sas Hard Drive Blank - HP ProLiant DL385 G7 Maintenance And Service Manual

Cable management arm with right-hand swing
NOTE:
To access the product rear panel components, open the cable management arm:
Power down the server (on page 26).
1.
Swing open the cable management arm.
2.
Remove the cables from the cable trough.
3.
Remove the cable management arm.
4.

SAS hard drive blank

CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
Remove the component as indicated.
To replace the blank, slide the blank into the bay until it locks into place.
To access some components, you may need to remove the cable management arm.
For proper cooling do not operate the server without the access panel, baffles,
Removal and replacement procedures 29