Hot-Plug Fan - HP ProLiant DL385 G7 Maintenance And Service Manual

Extend or remove the server from the rack
2.
server from the
Remove the access panel
3.
Disconnect the cable from the optical drive.
4.
Remove the optical drive
5.
Remove the optical drive cage.
6.
To replace the component, reverse the removal procedure.

Hot-plug fan

CAUTION:
and 6 in a single-processor configuration.
The only two valid fan configurations are listed in the following table.
rack" on page 27).
("Access panel" on page 33).
("Optical drive" on page 33).
To avoid damage to server components, fan blanks must be installed in fan bays 5
("Remove the server from the
Removal and replacement procedures 35
rack" on page 27, "Extend the