Rap 26 Transmit And Receive Errors - Xerox Document Workcenter 150 Service Manual

RAP 26 Transmit and Receive 6. Problem occurs only when remote machine initiates the transmission.
Errors
i N
The remote operator should call for service.
This procedure is used to isolate system
7. Ask the remote customer to contact the TELCO vendor for assistance.
components which contribute to on line
communications failures.
8. Turn off ECM and try the test again.
Initial Actions
The test completes normally without communications error codes.
* All normal system checks have been i
N Contact the next level of support for additional assistance.
completed successfully.
9. Go to step 5.
Procedure
1
2,
3.
4.
I
5.
The problem occurs during a send
operation.
i :o to step 4.
Send a two page lest document to a known
good machine.
The test completes normally without
communications error codes.
i
N Contact the next level of supporl for
additional assistance.
Repeat the two page test with the machine
that caused the original problem. If the
problem still exists, contact the next level of
support for additional assistance.
Receive two test copies from a known good
machine.
The test completes normally without
communications error codes.
i kAep8.
Repeat the two page test with the machine
that caused the original problem.
Test completes normally without
communications error codes.
i
N The remote operator should call for
service.
'~~,~, RAP 26 Transmit and Receive Errors
%~~~*;
'%.
12196
2 20
Document Workcenter 150