Rep 5.4 Encoder Assembly - Xerox Document Workcenter 150 Service Manual

REP 5.4 Encoder Assembly L,
Part List on PL 5.1
Adjustments
Removal
1. Head Gap (ADJ 5.2)
CAUTION
2. Grid Adjust (ADJ 5.1)
Leaving the Ink Cartddge rsmoved for long
periods of time witI cau.se the ink no.zles to
dry
out.
Image quality problems or a blank
print could result. N necessary. prime the Ink
Cadddge after reinstaflation.
1. Disconnect the Power Cord from the outlet.
2. Remove the following:
a. Ink Cartridge Cover (PL 3.1).
b. Ink Cartridge.
C. Rear Cover (REP 1.2).
d. Printer and Tray Assembly (REP 3.1).
e. Printer Assembly (REP 3.2).
f. Carriage Assembly (REP 3.5).
3. Turn the Carriage Assembly over and remove
the Encoder Assembly (Figure 1).
a. Disconnect the two (2) Belt Tension
Springs.
b. Disconnect CN7.
c. Remove the Encoder Assembly.
Replacement
1. Reinstall the Encoder Assembly
a. Reinstall the belt around the pulleys.
b. Finger tighten the hvo (2) screws.
c. Connect the two (2) Belt Tension Springs.
d. Move the Carriage horizontally to ensure
there is no backlash.
e. Tighten the hvo (2) mounting screws.
2. Reinstall the remaining components in the
rwerse order.
Encoder Assembly
Figure 1
Removing the Encoder Assembly
Document WorkCenter 150
5/96
4-25
REP 5.4 Encoder Assembly