Xerox Document Workcenter 150 Service Manual page 83

Replacement
1. Reinstall the Micro Gap Adjusters
2. Reinstall the Carriage onto the Shaft.
3. Reinstall the Bushing and Gap Adjust Lever
onto the Shaft.
NOTE: Ensure the Belt and Cable am
muted comctly before reinstalling the
Shaft.
4. Reinstall the Carriage (Figure 1).
a. Engage the front of the Carriage with the
Carriage Frame.
b. Reinstall the right end of the Shaft
assembly into the Micro Gap Adjuster.
c. Reinstall the left and of the Shaft
assembly into the Micro Gap Adjuster.
d. Reinstall the Right Gap Adjust Plate.
e. Reinstall the E-ring.
f. Reinstall the Ground Plates (2).
9. Secure the flex cable with the cable
damps.
5. Reinstall the remaining components in the
reverse order.
Adjustments
1. Head Gap (ADJ 5.2)
2. Grid Adjust (ADJ 5.1)
I
:li '
Document WorkCenter 150
5/96
4-27 REP 5.5 Carriage