Xerox Document Workcenter 150 Service Manual page 86

REP 5.7 Cartridge Support/Sensor Assembly
Parts List on PL 5.1
CAUTION
Leaving the Ink Cartridge removed for long
periods of time wilt cause the ink nozzles to
dv out. tmege quality problems or a blank
print could results. If necessary. prime the Ink
C&ridge after reinstatlation.
Removal
1.
2.
Remove the Cam Pin (REP 5.6).
Remove the Carriage SupportlSensor
Assembly (Figure 1).
a. Disconnect the Head Ribbon Cable at the
carriage connector by sliding the
connnector locking tab away from the
connector on both sides.
b. Slide the cable out of the connector.
c. Remove the Carriage SupporVSensor
Assembly.
Replacement
1. Engage the lab on the front of the Carriage
Support/Sensor Assembly with the carriage
frame (Figure 1).
2. Ensure the coil spring is fully seated.
3. Reinstall the remaining components in the
reverse order.
Cartridge Suppoti
Sensor Assembly
Figure 1
Removing the Carriage SuppotiSensor Assembly
REP 5.7 Cartridge Support/Sensor Assembly
4-N Document WorkCenter 150