Rep6.3Tankandseal - Xerox Document Workcenter 150 Service Manual

REP 6.3 Tank and Seal
Part List on PL 6.1
CAUTION
Leaving the Ink Cadddge removed for long
periods
of
lime will cause the ink nozzles to
dry out. image quality problems or a blank
print
could
mull.
If news&y,
prime
the Ink
Carlridge after rsinstallatton.
1. Disconnect the Power Cord from the outlet.
2. Remove the following:
a.
Ink Cartridge Cover (PL 3.1).
b. Ink Cartridge.
c. Rear Cover (REP 1.2).
d. Printer and Tray Assembly (REP 3.1).
e. PrinterAssembly (REP 3.2).
f.
Carriage Assembly (REP 3.5).
CAUTION
The Seal is inside the Tube. The Seat allows
air to
pass
until it comes in
contact
with ink.
If
Ink contacts the Seat. reolace the Tube and
Sd.
3. Remove the Tank (Figure 1)
a.
Disconnect the Pump Tube.
b. Carefully remove the Tank by pulling it in
the direction shown.
4. Carefully remove the Tube and Seal.
Replacement
1. Ensure that the Pump Tube is routed to avoid
restrictions.
2. Reinstall the remaining components in the
reverse order.
Adjustments
1. Head Gap (ADJ 5.2)
2. Grid Adjust (ADJ 5.1)
Pump Tube
Figure 1
Removing the Tank
5196
Document WorkCenter 150 4-33
REP 6.3 Tank and Seal