Rear Wheel Removal; Rear Axle/Final Driven Sprocket; Rear Tire Disassembly/Assembly; Rear Axle Removal - Honda ATC200S Workshop Manual

REAR WHEEL
REMOVAL
Raise the rear wheels off the ground with a
jack or block under the engine.
Remove the rear wheel nu ts.
Remove the rear wheels.
REAR T IRE DISASSEMBLY!
ASSEMBLY
For lire disassembly, assemt>v. and repair,
refer to page 11·12.
INSTALLATION
lnSlall each rear wheel with the lire vatve
facing out .
Tighten the wheel nu15 .
TORQUE: 20- 25 N·m (2.0- 2.5 kg -m.
14- 18ft-lbl
REAR AXLE/ FINAL DRIVEN
SPROCKET
REAR AXLE REMOVAL
Raise the rear wheels off the gorund w ith a
iack or block under the engine.
Remove the rear wheel nuts and rear wheels.
Remove t he cotter pin from the axle shaft and
loosen the wheel hub nut.
Remove the hub nun, loc k washer and wheel
hubs from the shaft.
REAR WHEEUBRAKE / DRIVE MECHANISM
HUB NUT
LOCK WASHER
,
"-
CO,;",
"N
171
12-3