Float, Float Valve And Jets; Throttle Cable Replacement - Honda ATC200S Workshop Manual

THROTTL E CABLE REP LACEMENT
AI!~r '85:
NOTE:
For after
'85
models, there are two types
of ca rbu reto r top and t hrottle cable as-
semblies. T hey are: in tegral and tl ip-on,
The integral cable is manuf actured so that
it must be replaced with the carburetor
top as an assembly,
The clip-on type cable lcable clips into the
carbu retor top) ca n be replaced sepa rate ly
w it hout the top .
The replacement instructions for the clip-
on type are below :
Make a U·cl ip as shown, using 1 mm (0,04
in) diameter wire . 6e sure to cut th e ends
of the U-clip as shown
Turn the carb ureto r top to al ign the holes
in the tOP w ith the grooves in the cable end.
Insert the ends of the U·clip thrOugh the
holes in the top and into the grooves in the
cable end.
Press the cl ip in with a pair of pliers to
expa nd the reta ining ring and separate t he
cable from the top
Check that the retai ning ring is in t he g roove
in the carbureto r top. Slide the end 01 t he
new cable through the hole in the carbure-
tor top until the retaining ri ng seats in the
cable end
Pull o n I he cable to be sure it is secured by
the retaining ring .
FLOAT. FLOAT VALVE AND JETS
Remove the Iloal chamber body.
Remove I he f loa t arm pin w ith pliers.
Remove the float and float valve.
FUEL
SY STEM
HOLES
RETA INING RING
CABLE
FLOAT VALVE
FLOAT ARM
PIN
47
4-9