Carburetor Assembly; Float Level Measurement; Throttle Valve Assembly; Fuel System - Honda ATC200S Workshop Manual

CARBURETOR ASSEMBLY
Carburetor assembly is essent ially the reverse
order of disassembly.
NOTE
• Use new O·rings when the carbu retor
is reassembled.
• Handle all jels ar.d needles WiTh care.
They can easi ly be scored or sc ralch-
.d.
• Sel The pi lOT screw TO Th e POSiTion
recorded during disassembly .
FLOAT LEVEL MEASUREMENT
Remove Ih e lIoal c h amber body .
Measvre The floaT level wilh the 1I0at tang
JUSt rest ing aga insI the lIoal valve.
FLOAT LEVEL, 14 .0 mm (0 .55
i,., )
Rep lace Ihe floal if th e float level is not
withm speci fIcatIon . The fioal is not ad -
Justab le
THROnLE VALVE ASSEMBLY
Install the needle clip on the jet needle .
STA NDAR D SE TTIN G: 3rd IIroowe
Inslall the jel needle into Ihe throttle valve
and secure il with lhe needle clip retainer.
49
PILOT
SLOW
m
f LOAT LEVEL GAUGE
01401 - 0010000
JET NEEDL E
FUel SYSTEM
NEEDLE
JET JET HOL DER
THROTT L E
STOP SCREW
FLOAT TANG
NEEDLE CLIP
4-11