Cam Chain Tension; Carburetor Idle Speed; Fuel Line - Honda ATC200S Workshop Manual

MAI NT ENANCE
CAM CHAIN TENSION
Start the engine and allow it to idle.
Remove the rubber cap and loosen The cam
chain ten\\oner adiu\ting bolt .
When the cam chain Tensioner adjuSTing bolt is
loosened. The Tensioner will aUTomatica lly
po.itio n
i T~elf
to provide The correct t ension.
Retighten the adjusTi ng bolt and inst all the
rubber cap.
TORQUE : 15-22 N·m (1.5-2. 2 kg-m,
11 - 16ft·lb)
NOTE -
DO not IIttempT to loosen the check
bolt wh ile adjust ing,
CARBURETOR IOLE SPEEO
NOTE '
• Insp(!c\ and adjust the idle sp(!lId
aller all other maintenllnce itams
are within spec il icat ions
• The engine must be warm lor ac-
curate idle speed inspe<:tion and ad·
justment.
Warm up The eng ine for about ten m inutes.
Turn the thrott le stop SCrew as required to
Obtain the specif ied idle speed.
IDLE SPEEO: 1,400±100 rpm
FUEL LINE
Replace any parts which show signs of
de ter ioration. damage Or leaks.
3-8
n
ADJUSTING BO LT
THROTTLE STOP SCREW