Port Settings For An External Controller ("6. Network Setup" ➝ "Ip Ctrl Port #"); Initializing The Acd1 - Yamaha ACD1 Reference Manual

■ Port settings for an external controller
("6. Network Setup" ➝ "IP Ctrl Port #")
Here you can specify the port number that will be used to control the ACD1
from an external device such as an AMX or Crestron unit.
Parameter
Port No. 49153–50049

Initializing the ACD1

Here's how to initialize the ACD1's internal memory.
• When you initialize the internal memory, the content that had been saved in memory (scenes for each amp, and ACD1
settings) will be lost.
CAUTION Use caution when performing the following steps.
1.
Power-off the ACD1.
2.
While holding down the [BACK] button, turn the power on.
3.
Press the [▲INC/YES] button to initialize the internal memory.
• Do not turn off the power during the initialization process.
CAUTION
4.
When initialization is completed, the ACD1 will automatically restart.
• The log data is preserved even if you execute initialization.
NOTE
Range
Specifies the ACD1's port number. Change the port number if there are other devices
(other than the ACD1) that use the same port number.
Initialize
Are you sure?
IP Ctrl Port #
Port number (hexadecimal)
Panel operations
49153
å
17
ACD1 Reference Manual