Panel Operations - Yamaha ACD1 Reference Manual

Panel operations

By pressing buttons on the panel you can monitor or control various parameters of the ACD1 itself or of the con-
nected amplifiers.
The following parameters can be monitored/controlled.
Category Sub category
1. Scene Recall
(page 10)
Store
2. Amp Control On/Standby
(page 11)
Mute
Attenuation
3. Output Monitor
(page 12)
4. Device Setup Device ID
(page 12)
Device Label
Identify
5. Utility Battery
(page 13)
Firmware Ver.
LCD Backlight
Panel Operation
Scene Recall
EMG Scene Setup
Last Mem. Resume
Clock
GPI Calibration
6. Network Setup IP Address Mode
(page 16)
IP Address
MAC Address
IP Ctrl Port #
Operation performed
Recalls a scene on the specified amplifier.
Saves a scene for the specified amplifier.
Switches the power of the specified amplifier between On and Standby.
Mutes or unmutes the channel of the specified amplifier.
Adjusts the channel attenuator value of the specified amplifier. (PC-N/Tn series
only)
Displays the output level of the specified amplifier.
Specifies the ACD1's Device ID address.
Displays the name of the ACD1 assigned by Amp Editor.
Blinks the "Identify" icon of the corresponding ACD1 in Amp Editor.
Displays the state of the ACD1's internal backup battery.
Displays the ACD1's firmware version.
Selects whether the ACD1's LCD backlight will be always lit (ON) or lit only during
operation (Auto OFF).
Restricts panel operations of the ACD1.
Specifies whether scene recall from the ACD1's panel is enabled (Enable) or dis-
abled (Disable).
Specifies the scene number that will be recalled when the EMG (Emergency) sig-
nal is received from an external controller. If this is OFF, a scene will not be
recalled even if an EMG signal is received.
Specifies whether the ACD1 will start up with the settings that were in effect when
the power was last turned off (ON) or whether it will start up by recalling the amp's
scene number that was in effect when the power was last turned off (OFF).
Sets the date and time of the ACD1's internal clock.
Calibrates the [GPI IN] connector input voltage.
Selects whether the ACD1's IP address will be set automatically from Amp Editor
(Auto) or set manually (Manual).
Specifies the ACD1's IP address.
Displays the ACD1's MAC address.
Specifies the port number used when controlling the ACD1 via Ethernet from an
external controller such as AMX/Crestron.
7
ACD1 Reference Manual