Terms - Yamaha ACD1 Reference Manual

Amplifier control device

Hide thumbs Also See for ACD1:

Table of Contents

Introduction

Terms

This section explains terminology speciﬁc to the ACD1.

■ Amp Editor

This is computer application software. With this software, you can use your computer to monitor and control the ACD1 and

the ampliﬁers connected to the ACD1.

■ Scene

Settings such as Power-On/Standby or mute for each ampliﬁer are collectively called a "scene." By recalling a scene, the

saved settings can be immediately applied to the ampliﬁers. The ACD1 can specify 49 scenes for each connected ampliﬁer.

■ Scene link

Settings for simultaneously recalling scenes for multiple ampliﬁers within an area are called a "scene link." By recalling a

scene link, scenes can be simultaneously recalled for multiple ampliﬁers. Scene links can be created and recalled using

Amp Editor.

■ Device ID

This is an ID for uniquely identifying an ACD1 unit within a network. If there are duplicate IDs within an area, it will be

impossible to monitor/control them from Amp Editor.

■ Amp ID

This is the ID of each ampliﬁer connected to the ACD1. Ampliﬁers connected to the [DATA PORT] connector of the same

ACD1 must be set to non-overlapping IDs using the [AMP ID] switch located on the rear panel of each ampliﬁer. For ampli-

ﬁers connected to a [MONITOR/REMOTE] connector, the Amp ID is determined by the connector that is used.

ACD1 Reference Manual

Table of Contents