Enabling Scene Recall Operations Via Emg Commands ("5. Utility" ➝ "Emg Scene Setup"); Last Memory Resume Setting ("5. Utility" ➝ "Last Mem. Resume"); Clock Setting ("5. Utility" ➝ "Clock") - Yamaha ACD1 Reference Manual

■ Enabling scene recall operations via EMG commands
("5. Utility" ➝ "EMG Scene Setup")
Specifies whether the EMG scene will be recalled when the EMG (Emer-
gency) signal is received.
The following three types of EMG signal can be received.
• EMG command sent from AMX/Crestron
• Input signal to the GPI IN assigned to the Emergency scene
• EMG command sent from a different ACD1 unit
Parameter
Amp ID 00–39, ALL
EMG Scene Setup 00–49
OFF
• If you select "ALL" as the [Amp ID], the EMG Scene Setup area may indicate "Some ON." This means that EMG scene
NOTE
recall is enabled for some amplifiers but disabled for other amplifiers.
■ LAST MEMORY RESUME setting ("5. Utility" ➝ "Last Mem. Resume")
This specifies whether the unit will start up in the state in which it was pow-
ered-off, or recall the scene of the scene number that was selected at power-
off.
Parameter
Last Mem. Resume ON
OFF
■ Clock setting ("5. Utility" ➝ "Clock")
Sets the date and time of the ACD1's internal clock.
Parameter
Date 01–31
Month Jan–Dec
Year 00–99
Hour 00–23
Minute 00–59
• The seconds will be set to 00 when you finalize the time.
NOTE
• If Daylight Saving Time is enabled in Amp Editor, this will indicate "DST."
Range
Specifies the ID of the amp for which EMG scene recall will be enabled. If you select
"ALL," the EMG scene recall enable status of all amplifiers will be switched to the
specified state.
Recalls the specified scene.
A scene will not be recalled even if an EMG signal is received.
Range
The unit will start up in the state in which it was powered-off.
At start-up, the unit will recall the scene that was last recalled or stored before the
power was turned off.
Range
Sets the date.
Sets the month.
Sets the year. The last two digits of the Western calendar year can be specified.
Sets the hour.
Sets the minute.
Amp ID:
Explanation
Last Mem.Resume
Explanation
Clock
01-Oct-09 16:43
å
Explanation
ACD1 Reference Manual
Panel operations
01
å
OFF
ON
å
DST
15