Controlling An Amplifier ("2. Amp Control"); Power On/Standby ("2. Amp Control" ➝ "Standby"); Mute ("2. Amp Control" ➝ "Mute"); Attenuator Value Adjustment ("2. Amp Control" ➝ "Attenuation") - Yamaha ACD1 Reference Manual

Controlling an amplifier ("2. Amp Control")
These settings allow you to control an amplifier connected to the
ACD1.
■ Power on/standby ("2. Amp Control" ➝ "Standby")
Switches the power of the specified amplifier between On and Standby.
Parameter
Amp ID 00–39, ALL
Power supply status Standby/On
• If you select "ALL" as the [Amp ID], the power supply status may indicate "Some Standby." This means that the power is
NOTE
On for some amplifiers, and Standby for others.
■ Mute ("2. Amp Control" ➝ "Mute")
Mutes or unmutes the channel of the specified amplifier.
Parameter
Amp ID 00–39, ALL
Amp Ch A–H, ALL
Mute status Muted/Unmuted
• If you select "ALL" as the [Amp ID], the mute status may indicate "Some Muted." This indicates that there are both muted
NOTE
and unmuted channels.
■ Attenuator value adjustment ("2. Amp Control" ➝ "Attenuation")
Adjusts the channel attenuator value of the specified amplifier. The attenuator
value can be adjusted only for amplifiers (as of September 2009: the PC-N/
Tn series) connected to the [DATA PORT] connector.
Parameter
Amp ID 00–31
Amp Ch A–H
Attenuator value 0 dB– -78 dB, -
Range
Selects the ID of the amplifier whose power will be switched. If you select "ALL," the
power of all amplifiers will be switched to the specified state.
Selects the status of the power supply.
Range
Selects the ID of the amp whose channel is to be muted. If you select "ALL," the mute
status for all channels of all amplifiers will be switched.
Selects the channel whose mute status is to be switched. The range of channels that
can be selected will depend on the amplifier you select. If you select "ALL," the mute
status for all channels of the selected amplifier will be switched.
Selects the mute status.
Range
Selects the ID of the amp for which the attenuator value of a channel is to be adjusted.
Selects the channel whose attenuator value is to be adjusted. The range of channels
that can be selected will depend on the amplifier you select.
∞
Selects the attenuator value.
The selectable range is 0 dB through -44 dB in 1 dB steps, -44 dB through -78 dB
in 2 dB steps, with -78 dB followed by -
å 2 .Amp Control
Standby
Amp ID:
Standby
Explanation
Amp Ch:
Muted
Explanation
Amp Ch:
-48.0dB
Explanation
∞
.
ACD1 Reference Manual
Panel operations
01
å
A
å
A
å
11