Config Screen - AJA Ki Pro Quick Start Manual

Config Screen

Ki Pro Installation and Operation Manual — Web Browser via Ethernet
The Config screen is a general purpose screen used to configure Ki Pro's I/O
choices, conversion choices, and also set up Ki Pro's environment (name, clock
settings, display etc.)
Ki Pro Web Interface, Config Screen
Note: In the following web screen control definitions, the number in
parentheses refers to the Parameter descriptions in Chapter 2—you can
read more information there about the choices and their meanings.
Record Type (1.1): This parameter defines the frame recording method of media
stored. RECORD TYPE can be configured to record the incoming video signal
in a "NORMAL" manner, as a "PsF" signal if the incoming source is 1080psf
29.97 (for example), or VFR for variable framerate recording of the SD-SDI/
HD-SDI input (such as Varicam).
1080p Playback (1.3): This parameter defines the format applied when 1080p
media is played bac k off from storage. You can choose Playback as standard
1080p progressive frame or 1080 progessive segmented frame (regardless of
what was recorded when input).
In Convert (1.4): This parameter defines the type of up, down, cross, or aspect-ratio
conversion, if any, applied to the selected input when recording. Selections
are None, SD, HD 720, or HD 1080.
Out Convert (1.5): This parameter defines the type of up, down, cross, or aspect-
ratio conversion, if any, applied to the output. Selections are None, SD, HD
720, or HD 1080.
SDI Output (1.6): This parameter defines whether the SDI output matches the file
format or has the 1.5 OUT CONVERT selection applied to it.
Component Output (1.7): This parameter defines whether the component video
output matches the file format or has the 1.5 OUT CONVERT selection
applied to it.
79
1