Cvbs Composite Ntsc/Pal Output; Hdmi; Analog 2 Channel Balanced Audio Input And Output; Analog 2 Channel Unbalanced Audio Input And Output - AJA Ki Pro Quick Start Manual

24

CVBS Composite NTSC/PAL Output

One BNC connector supplies composite NTSC or PAL output. Connect the
CVBS Out BNC to a monitor, or other Composite video device. Composite
video signals are D/A (output) converted (10-bit).
Note: Composite video output follows the settings made for the component video output;
because of this, if a composite output is desired when working with HD, the component
video output must be set to SD.

HDMI

Two HDMI connectors provide for input and output of HDMI compatible video
and embedded audio. HDCP sources are not supported on the input. The
HDMI input is designed to support long cable runs: up to 100 feet (30.48m)
when using 22 or 24AWG HDMI cable, or up to 50 feet (15.24m) using 28 or 30AWG
HDMI cable. The HDMI output supports standard HDMI cables only.
HDMI formats supported:
525i 29.97
625i 25
720p 50, 720p 59.94
1080i 25, 1080i 29.97,
1080p 23.98, 1080p 24, 1080p 25, 1080p 29.97
Note: When using Ki Pro HDMI connections and attaching it to any HDMI audio or video
accessory, you must use one each of the ferrite beaded HDMI cables, HH-28F-06, between
the input and output ports of the Ki Pro and the HDMI accessory to maintain regulatory
compliance.

Analog 2 Channel Balanced Audio Input and Output

Four XLRs, 2 female for input and 2 male for output, provide 2
channels of balanced audio. Audio is high-quality 24-bit A/D
input and D/A output at 48kHz. Level adjustments are made via
software and a switch for line-level inputs. Software level
adjustments for analog audio (parameter 4.1) apply to balanced
audio (XLR) using the "Line" setting on the switch. The Mic and
Mic +48 settings offer a lower input level suitable for
microphones and their associated input impedance. Use Mic
+48 for microphones with phantom power (condenser mic.), or Mic for microphones
without phantom power (dynamic micrphones).

Analog 2 Channel Unbalanced Audio Input and Output

Two RCA connectors provide an unbalanced stereo audio input pair for use with
consumer camcorders, VTR/VCRs and other A/V devices. For output, two RCA
connectors provide an unbalanced stereo audio output pair for driving inexpensive
audio monitoring systems.

9-pin Connector

Ki Pro features a 9-pin serial port that may be used with some RS-422
devices. IMPORTANT: Not all RS-422 devices have been tested with Ki
Pro, so AJA cannot definitively say which devices may or may not communicate as
expected with Ki Pro when operated under RS-422 remote control. Refer to the latest
Release Notes document for which devices or non-linear editors have been tested
with Ki Pro operating under RS-422 control.