Subnet Mask; Static Gateway; System Name - AJA Ki Pro Quick Start Manual

50.3 SUBNET MASK

50.4 STATIC GATEWAY

50.5 SYSTEM NAMEE
Ki Pro Installation and Operation Manual — CONFIG menus
50.3 SUBNET MASK
This parameter determines the subnet mask used by Ki Pro for TCP/IP networking.
variable
Please read the "Note" about editing IP addresses in parameter 50.2 as it also applies to
parameters 50.3 and 50.4.
50.4 STATIC GATEWAY
This parameter determines the gateway or router used by Ki Pro on your LAN for TCP/IP
networking.
variable
Note: Without a properly configured default gateway (whether you have a router/gateway or
not), Ki Pro will be unable to see other Ki Pros on the network, although you may still be
able to control the Ki Pro via a web browser. Also, without a proper gateway defined, the
discovery feature "Available Ki Pros—Click to Refresh" on the Network web page will not
work correctly and list other Ki Pros on the network.

50.5 SYSTEM NAME

This parameter defines a name for Ki Pro and gives it a unique identifier. This same
name is used both when displaying systems via the web interface/802.11b/g and for
display on Ki Pro's screen saver (if System name is chosen in Parameter 70.1 Screen
Saver).
variable
Using the adjust buttons, enter a subnet mask compatible
with your LAN (if you have one). This is only needed for
Static IP configurations.
If 50.1 is set to DHCP, the default Subnet Mask will be
assigned by the DHCP server
If 50.1 is set to Default Addr, the default Subnet Mask is:
255.0.0.0
Using the adjust buttons, enter a gateway compatible
with your LAN (if you have one). This is only needed for
Static IP configurations.
If 50.1 is set to DHCP, the default gateway will be
assigned by the DHCP server
If 50.1 is set to Default Addr, the default gateway is:
10.0.0.1
Using the adjust buttons, enter a name for Ki Pro. Using
the adjust buttons and the top Select button, select the
characters for each of the up to 20-character name. The
adjust buttons scroll through the choices and the top
Select button advances to the next character. While
selecting characters, the character being changed will
flash to show its position. The character set allowed is: 0
through 9, '-','.', A through Z (uppercase) and a through z
(lowercase).
Default: AJA Ki Pro
69
1