Recording Notes; Playing Back A Clip - AJA Ki Pro Quick Start Manual

44

Playing Back a Clip

To select a different video input, press CONFIG, then repeatedly press SELECT until
you see 2.1 Video In. Then press ADJUST up or down to choose a desired video input
connector. To select a different audio input, use the SELECT up arrow button and you
will see 2.2 Audio In. Press ADJUST up or down to chose a desired audio input
connector.
Note: You cannot select HDMI audio unless you have an HDMI video source, nor can you
select an SDI audio source if you have not selected an SDI video source. If you attempt to
mismatch these settings, a warning will alert you to the mismatch on the front panel.
These are just a few menu parameters that you might wish to change before you
make your recordings. To learn all the ways to convert formats on input or output
read the CONFIG menu and MEDIA menu parameter topics later in this chapter.

Recording Notes

• Ki Pro may take a few seconds to close longer files (files over 20 minutes). For
these longer recordings, you may see a "Closing File" prompt on the display.
• Ki Pro alerts you when the media is nearly full with a "Media Low" prompt at 15%
of the remaining capacity. At 10% of the total capacity of the media, the "Media
Full" prompt will appear. Any recordings that have been started will stop once
10% is reached and no further recordings can be performed using this media
until it is formatted again or a MEDIA>Delete Clips>DELETE ALL has been
performed. Deleting clips to produce more than 10% free space will allow
recording to resume.
To playback recorded media, you simply select the clip desired and press PLAY. If the
clip you wish to playback is not currently selected, use the SELECT up/down buttons
until the clip name appears on the display. Like recording, there is more than one way
to initiate playback (front panel, web browser, and wireless). From the front panel
these are the basic steps:
1. Press the STOP button to get to the TRANSPORT mode (if not already there).
Find the clip name in the display (it shows the current clip/reel).
2. Press the SELECT up or down arrow button repeatedly until you find the clip
you are looking for.
3. Press the PLAY (>) button.
4. When playing back a clip (PLAY, FF, or REV) the first push of STOP acts as a
"Pause" mode: the playback is paused, the current point of the clip is displayed,
and the STOP button will flash. A second push of STOP will completely stop the
playback and Ki Pro's outputs will go into an "E to E" mode (the currently
selected inputs will be bypassed to the outputs). When a playback reaches the
end of a clip, it will automatically pause on the last frame of the clip.