Tc Value; Tc Type; Arm Recording; Interval Record - AJA Ki Pro Quick Start Manual

62

8.1 TC VALUE

8.2 TC TYPE

8.3 ARM RECORDING

9.0 INTERVAL RECORD

8.1 TC VALUE
This parameter selects the starting hour for timecode
00:00:00:00 to
23:00:00:00
(Default: 01:00:00:00)
8.2 TC TYPE
This parameter selects drop frame or non-drop frame timecode.
Note: If the TC In is SDI RP188, LTC, FW400, or RS422, the TC Type selection does not apply. TC
Type only applies to the TC Value or the Time of Day value generated by Ki Pro.
NDF (default)
DF
8.3 ARM RECORDING
This parameter selects how recording will begin: either by pressing record button (or
web "Record" button) or via timecode. If starting on timecode, parameters 8.0, 8.1.
and 8.2 must be set to qualify the source and type of timecode.
Note: For TC/REC KEY to operate, a record run timecode with incrementing values and starts/
stops is needed. Freerun timecode does not provide this and is not applicable to the TC/
REC KEY selection.
REC KEY (default)
TC/REC KEY
LANC/REC KEY
9.0 INTERVAL RECORD
The Ki Pro can be used to create timelapse recordings via the 9.0 Interval Record, 9.1
Interval Frames and 9.2 Interval Time selections. Note that the 9.1 and 9.2 menu
options will not appear unless 9.0 Interval Record is enabled.
OFF (default)
ON
Example of timelapse recording selections:
The incoming video signal is 1080i 29.97 fps, the record button is depressed, and the
recording is then stopped 90 seconds later with the following settings:
9.0 Interval Record > On
9.1 Interval Frames > 1
9.2 Interval Time > Second
The resulting recording would be 90 frames in duration, would have a frame rate of
29.97 fps, and would appear to be "undercranked" or "sped up" when compared to a
normally created recording.
Note: selecting an interval frame number that exceeds the incoming video frames
per second will result in normal video. "Overcranking" or "slow mo" is not supported
by the interval recording feature.
when 8.0 is set to TC Value
Use the ADJUST buttons to select a timecode hour.
01:00:00:00,
For example:
Selects Non-drop Frame timecode
Selects Drop Frame timecode
Start when Record button is pressed
Start on Time Code trigger or Record button
Start Ki Pro under LANC or REC button control. When
selected and you have a LANC controller connected to
the Ki Pro and looped out to the camera, the Ki Pro will
go into record when you hit Record on the LANC
controller.
Normal recordings are produced.
Timelapse recordings are produced.
.
02:00:00:00, etc.
"