Installation - Nimbus Water Systems Sierra Owner's Manual & Installation Manual

INSTALLATION

1
Before You Begin
The following instructions outline a typical water treatment system installation. Consult local
plumbing codes and building regulations as they may pose different or additional requirements for
the installation. The installer is responsible for ensuring that the installation is in compliance with all
applicable state and local regulations.
This system has been designed for installation by a licensed professional such as a contractor or
plumber. Proper completion of this installation will require basic familiarity with standard sink
plumbing and proper use of common hand and power tools. Improperly installed systems could result
in water damage due to leaks or flooding.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
A. Product water storage tank
B. Tank shut-off valve
C. Tank tubing (3/8" white)
D. Air-gap faucet
E. Drain connection assembly
F. Drain tubing (3/8" white)
G. Quick-connect fitting
H. Drain tubing (1/4" yellow)
Typical Installation Diagram
I.
J.
K.
L.
M. Automatic shut-off valve
N.
O.
P.
7
Product water tubing (3/8" blue)
Reverse osmosis membrane filter
Carbon post-filter
Pre-filter
Inlet fitting with elbow
Feed water tubing (1/4" green)
Feed water shut-off