Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Nimbus Water Systems CS-2
Summary of Contents for Nimbus Water Systems CS-2
- Page 1 Nimbus CS-2 Reverse Osmosis System 41840 McAlby Court, Suite A Murrieta, CA 92562 800-451-9343, FAX 951-894-2801 www.nimbuswater.com REV: 0507 41840-A McAlby Court, Murrieta, CA 92562 05/09 (800) 451-9343, www.nimbuswater.com...
- Page 2 41840-A McAlby Court, Murrieta, CA 92562 (800) 451-9343, www.nimbuswater.com...
- Page 3 Introducti on to the CS-2 Congratulati ons on your purchase of the Nimbus CS-2 reverse osmosis system. When properly maintained, this system will provide you with years of trouble-free service. The next secti ons contain important informati on on the proper care and maintenance of your system, please take a few minutes to read through this informati on.
-
Page 4: Warranty
Other Rights This Warranty gives you specifi c legal rights and you may also have other rights which vary from state to state. Please fi ll out the form below and retain for future reference. Nimbus CS-2 Model: Date Code:... -
Page 5: Typical Installati On Diagram
Typical Installati on Diagram A. Product water storage tank B. Tank shut-off valve C. Tank tubing D. Air-gap faucet E. Drain connecti on assembly F. Drain tubing G. Quick-connect fi tti ng H. Product water tubing Membrane desalinator J. Carbon post-fi lter K. - Page 6 CS-2 Push Handle Faucet For easier installati on, att ach all tubing prior to mounti ng the faucet. 1. Insert polished faucet base onto base of faucet. 2. Push the 1/4” drain tubing onto the 1/4” barb fi tti ng. This tube must be of suffi...
- Page 7 CS-2 Feed and Drain Connecti ons Feed Connecti on 1. Locate and turn off the angle stop valve on the cold water line feeding the sink where the system is to be installed. This valve will usually be located under the sink on the pipe coming out of the wall.
-
Page 8: Tubing Connections
CS-2 Tubing Connecti ons 1. Measure and cut a length of 1/4" or 3/8" tubing (depending on model) long enough to reach from the faucet to the faucet connector on the system. Connect one end to the faucet nipple using a jaco nut and plasti c insert. Connect the other end to the faucet connecti on on the post-fi... - Page 9 Acti vati on and Flushing System Acti vati on and Inspecti on 1. Check all tubing connecti ons to ensure they are fi rmly seated and secure. 2. Open the dispensing faucet at the sink. Close the tank shut-off valve. 3.
-
Page 10: Installation Checklist
CS-2 Installati on Checklist 1. System is located where it will not be subject to physical impacts or rough contact by heavy objects. 2. Feed water pressure to the unit is no less than 40 psi and no greater than 80 PSI. -
Page 11: Maintenance
CS-2 Maintenance Desalinator Replacement Close the feed water shut-off valve and close the tank shut-off valve. To Drain Open the dispensing faucet to relieve system pressure. Close dis- (Yellow Collet) pensing faucet when fl ow has stopped. Remove old desalinator from clips on frame. Install new desalinator on frame.
Need help?
Do you have a question about the CS-2 and is the answer not in the manual?
Questions and answers