Ricoh SP 3600SF User Manual page 113

Message
"Authentication with the
destination has failed. Check
the settings."
"Cannot write on memory
device because remain.
space is insufficient."
"Cannot write on memory
device because the device is
write-protected."
"Cannot write on memory
device. Check memory
device and machine sett."
"Check the resolution and
reset nnn original(s)."
(A figure is placed at nnn.)
"Connection to PC failed.
Check the settings."
Causes
The user name and
password entered when
sending to a folder were
incorrect.
The memory device is
insufficient and scan data
cannot be saved.
The memory device is write
protected.
The memory device is faulty,
or the file name contains a
character that cannot be
used.
The scanned original
exceeded maximum data
capacity.
• The destination
computer name or
folder name is invalid.
• The entered user name
or password was
invalid.
When Messages Are Displayed on the Control Panel
Solutions
Enter the correct user name and
password, and try again.
Replace the memory device.
Unlock the write-protection on the
memory device.
• Check to see if the memory device
is defective.
• Check the memory device. It
might be unformatted, or its
format might be incompatible with
this machine.
• Check the file name set at the time
of scanning. For details on the
characters that can be used in file
names, see "Values of Various Set
Items for Transmission Function",
Scan . Check with your system
administrator.
Specify the scan size and resolution
again. Note that it may not be possible
to scan very large originals at a high
resolution. See "Relationship between
Resolution and Scan Size", Scan
• Check whether the computer
name and the folder name for the
destination are correct.
• Check that the user name and
password are correct.
.
111