Antenna; Fuse Replacement; Supplied Accessories; Microphone Hanger - Icom IC-M603 Instruction Manual

CAUTION: After connecting the DC power cable, cover
the connectors with a rubber vulcanising tape as shown
below, to prevent water seeping into the transceiver.
Rubber vulcanizing tape

■ Antenna

A key element in the performance of any communication
system is an antenna. Ask your dealer about antennas and
the best place to mount them.

■ Fuse replacement

One fuse is installed in the supplied DC power cable. If a
fuse blows or the transceiver stops functioning, track down
the source of the problem, if possible, and replace the dam-
aged fuse with a new, rated one.
Fuse rating: 10 A
CONNECTIONS AND MAINTENANCE

■ Supplied accessories

The following accessories are supplied
Mounting bracket For mounting bracket
Knob bolts
Screws (5×20 mm)
Microphone Accessory connectors
(3 pin, 6 pin)

Microphone hanger

and screws (3×16 mm)
Sponges
■ Microphone hanger
Rest the supplied microphone on the hanger when not in use.
Connect the microphone hanger cable* to the transceiver's
ground terminal with a self-tapping screw (3 × 8 mm) and the
other side to the microphone hanger to use the microphone
hanger function.
*Depending on version.
• If the microphone hanger function is used, Channel 16 is selected
automatically when the supplied microphone is rested on the hanger.
9
Flat washers (M5)
Spring washers (M5)
DC power cable
Microphone
hanger cable*
*Depending on the version
9
47