Hm-162E Installation - Icom IC-M603 Instruction Manual

■ HM-162E installation

HM-162E
The optional HM-162E should be installed to the transceiver
using the supplied connection cable.
The connector of the connection cable can be installed into a
cabinet, wall, etc., as a built-in plug.
For longer distance remote operation, the optional extension
cable, OPC-1541 (6m; connecting between the transceiver
and the connection cable), is available, and up to two OPC-
1541 can be added.
Do not connect the HM-162E to the OPC-1000.
q Insert the supplied cable into the [COMMAND MIC-1] or
[COMMAND MIC-2] connector and tighten the cable nut
as shown below.
• Up to two COMMANDMICIII™s can be connected simultaneously.
CONNECTIONS AND MAINTENANCE
w To use the supplied cable as a wall socket, perform the
following steps.
e Using the mounting base as a template, carefully mark the
holes where the cable and three screws will be fastened.
r Drill holes at these marks.
t Install the mounting base using the supplied screws as
shown below.
Mounting base
Gasket
Screw holes
(approx. 2 (d) mm)
9
[COMMAND MIC-1]
[COMMAND MIC-2]
Nut
Cap
Completed
9
51