Usb Devices; Mobile Device Charging - Cisco 8811 User Manual

Accessories
A list of phone accessories displays.
Step 3
Select an accessory from list and press Show Detail.
The phone screen displays the details of selected accessory. The information displayed on the phone screen
depends on the accessory selected. Most of the accessories provide these details:
• Device Name
• Hostname
• Device Type
• Device Service
• Firmware Version
• Paired Status (for Bluetooth devices)
• Connected Status
• Configured Status
Step 4 Press Setup to configure the selected accessory for your phone.
Step 5
Press Exit to return to the Applications screen.

USB Devices

Each USB port supports a maximum of five supported and nonsupported devices that are connected to the
phone. Each device connected to the phone is included in the maximum device count.
For example, your phone can support five USB devices on the side port and five additional standard USB
devices on the back port. Many third-party USB products contain more than one USB device, and thus count
as more than one device. For example, a third-party USB device may contain an internal hub and a headset,
and thus count as two USB devices.
If you use a USB hub and remove the USB cable from the phone or device port during an active call, it may
cause your phone or device to reboot. For more information, contact your system administrator.

Mobile Device Charging

You can use the USB port on your Cisco IP phone to charge your mobile device if the device has a USB
connection. USB charging is supported on the following ports:
• Side Port: Supports low current charging with a maximum value of 500mA charging current (2.5 Watt)
• Back Port: Supports SDP and DCP modes, with SDP supporting a maximum of 500mA charging current
and the DCP supporting fast charging with a maximum 2.1A charging current (10.5 Watt)
The back port is only available on the Cisco IP Phone 8861 and 8865.
Note

USB Devices

Cisco IP Phone 8800 Series User Guide
115