Accu-Scope EXC-500 User Manual page 10

DETAILED ASSEMBLY
②
①
Fig. 10
③
⑤
①
Fig. 11
②
Fig. 12
ACCU-SCOPE
®
(continued)
②
④
①
73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
EXC-500 MICROSCOPE SERIES
Installing the Objectives - (Fig. 10)
Rotate the coarse focusing knob
lowest position.
Install the objectives into the nosepiece
magnification to the highest in a clockwise direction
beginning with the first empty objective receptacle in front.
Install each objective by using two hands to position and
gently screw in the objective in a clockwise direction into the
threads of the nosepiece receptacle.
NOTE: Never force any objectives onto the threads of the
nosepiece, and do not over-tighten.
Installing the LED Lamp Housing - (Fig. 11)
Using the Hex wrench loosen the lock screw ① for the LED
lamp housing.
Align and install the lamp housing ② with the opening ③ in
the back of the stand as shown.
Retighten the lock screw ①.
Align the red dot on the LED lamp housing cable plug ④ with
the red dot on the top of the lamp housing port ⑤ on the back
of the microscope and slide the plug into the port for
transmitted illumination (
Installing the Power Cord - (Fig. 12)
Align and plug the female end ① of the power cord into the
power cord socket② on the back of the microscope.
Plug the other end into a grounded (3-prong) outlet.
NOTE:
Always use the power cord that is provided with your
microscope; using a different power cord may damage your
microscope. Should you need a replacement, contact your
authorized ACCU-SCOPE dealer or call ACCU-SCOPE
at 1-631-864-1000 for a dealer nearest you.
to lower the stage to its
①
from the lowest
②
).
10