Cleaning The Grease Tray Partition - Taylor QS11 Operating Instructions Manual

Step 3
Using the rubber wiper squeegee, push the grease to
the rear of the lower surface into the grease trough. DO
NOT use the grill scraper for this step.
Step 4
When necessary, use a grill cloth to clean the back
splash shield and the bullnose areas.
Step 5
Repeat Steps 1 through 4 for other side of the grill
(QS23 only).
Note: Whenever the grill is idle and product is not
being cooked, keep the upper cook surface in the
raised position.
When necessary, use the trough scraper to clean the
rear grease trough. If a buildup of carbon is starting in
the grease chute, use the hook end of the trough
scraper to push the carbon down into the grease tray.
Periodically, check the grease drawer for excess
grease and empty it as needed.
Figure 29

Cleaning the Grease Tray Partition

Occasionally, the grease tray partition must be
cleaned.
Step 1
Place the power switch in the OFF position.
Step 2
Carefully unplug the unit from the wall receptacle.
Step 3
Remove the grease tray.
090401
Operating Procedures
Step 4
Remove the four screws that secure the grease tray
partition.
Step 5
Carefully remove the grease tray partition. Take it to
the sink for cleaning.
Note: For installation of the grease tray partition,
carefully reverse the above steps.
It is highly recommended that the gap slides
and the gap slide retainers be removed at
least weekly for cleaning these parts and the
cook surface shroud behind these parts.
These parts are easily removed by removing
the locating pins and holding both parts,
because they are not attached together, and
pulling them from the cook surface.
Take the gap slides to the sink for cleaning.
(Be sure to re-install the gap slides as they
were removed, i.e., "F" front.) See Weekly
Cleaning Procedures on page 28.
26
Figure 30
Figure 31
Models QS11 & QS23
14123
14124