Weekly Cleaning Procedures - Taylor QS11 Operating Instructions Manual

Step 13
Clean lower grill by pouring warm water carefully on
the surface while brushing with sturdy brush.
CAUTION: Wear rubber gloves to avoid
hot steam.
Step 14
Continue to add water and brush the surface until the
grill is cool enough to squeegee dry.
Step 15
Wipe the cook surface(s) twice with a clean, damp
towel.
Step 16
Wipe all areas of the grill with a clean, damp towel.
Step 17
Wipe all exterior stainless steel panels around the
entire grill.
CAUTION:
Never use cold water or ice to cool the
S
upper cook surface or lower grill plate.
Never use grill screens on the upper cook
S
surface or lower grill plate.
Never use any other abrasives or cleaners
S
other than approved food service cleaners
and degreasers.
Never spray excessive amounts of water on
S
the grill.
Never pour or spray liquid of any type on
S
top of the upper cook surface.
090401
Operating Procedures
Step 18
Place release material sheet(s) on the warm lower grill
plate and thoroughly wipe down both sides with a
clean, damp grill cloth.
CAUTION:
Never attempt to clean release material
S
sheets on a cold surface.
Never use a hot hose for cleaning release
S
material,
Never soak release material sheets in liquid.
S
Never fold, crease or touch release material
S
sheets with sharp objects.
Never allow the grill scraper or abrasive
S
cleaning materials to come in contact with
release material sheets.
Step 19
Apply a light coat of shortening to the entire lower grill
plate.

Weekly Cleaning Procedures

Step 1
Loosen, but do not remove the four locating pins that
attach both sets of Gap Slide Retainers. One set is
located at the front and one set is located at the rear
of the upper platen.
Step 2
Lift the upper platen to the raised position. Remove
the four locating pins on both ends of the platen.
Step 3
Remove both sets of the Gap Slide Retainers and Gap
Slides. Take them to the sink for washing, rinsing and
sanitizing. Wipe dry with a clean, sanitized towel.
Step 4
Re-install the Gap Slide Retainers and the Gap Slides
in their original locations.
Note: The front Gap Slide set will be marked with an
( F ) to designate the front location. The rear set will not
be marked.
28
Models QS11 & QS23