Cleaning The Grease Tray Partition - Taylor QS10 Operating Instructions Manual

Step 3
Using the rubber wiper squeegee, push the grease
to the rear of the lower surface into the grease
trough. DO NOT use the grill scraper for this step.
Step 4
When necessary, use a grill cloth to clean the back
splash shield and the bullnose areas.
Step 5
Repeat Steps 1 through 4 for other side of the
QS22 grill.
Note: Whenever the grill is idle and product is not
being cooked, keep the upper cook surface in the
raised position.
When necessary, use the trough scraper to clean
the rear grease trough. If a buildup of carbon is
starting in the grease chute, use the hook end of the
trough scraper to push the carbon down into the
grease tray. Periodically, check the grease drawer
for excess grease and empty it as needed.
Figure 18
Models QS10 & QS22

Cleaning the Grease Tray Partition

Occasionally, the grease tray partition must be
cleaned.
Step 1
Place the power switch in the OFF position.
Step 2
Carefully unplug the unit from the wall receptacle.
Step 3
Remove the grease tray.
Step 4
Remove the four screws that secure the grease tray
partition.
21
Figure 19
Figure 20
Operating Procedures