Figure - Taylor QS11 Operating Instructions Manual

Step 8
Lower the upper cook surface into the COOK position.

Figure 9

Step 9
Wearing proper protection, attempt to rock the cook
surface assembly. Apply slight pressure on the
locating pins at opposite corners to each other as
shown in Figure 10.
Figure 10
Step 10
If the unit rocks, split the adjustment for gap pins
across the uneven corners, as shown in Figure 11.
Figure 11
Models QS11 & QS23
Step 11
After adjusting, verify the unit for stability/rock.
14115 Step 12
If all adjustments on the cook surface are correct, and
no rocking occurs, tighten the two allen screws located
on the sides of the front and rear gap slides to lock all
adjustments from moving.
IMPORTANT: It is highly recommended
that the gap slides and the gap slide
retainers (as shown in Figure 12) be
removed at least weekly for cleaning these
parts and the cook surface shroud behind
these parts.
These parts are easily removed by removing
the locating pins and holding both parts,
because they are not attached together, and
pulling them from the cook surface.
Take the gap slides and the gap slide retainers
to the sink for cleaning. (Be sure to re-install
the gap slides as they were removed, i.e., "F"
front.) See Weekly Cleaning Procedures
on page 28.
5
Figure 12
090401
To the Installer