Color Calibration Settings; Custom Static Colors & Preset Colors - Blizzard Lighting Colorise Quadra Manual

Color Calibration Settings:

Allows the user to setup and save 1 customized R/G/B/W color balance setting and save it for future use.
This custom setting is global, and it will effect all modes.
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to SET and press <ENTER>,
then on while CAL, push <ENTER> again.
2.) Use the <UP/DOWN> buttons to highlight either R (Red Level), G (Green Level), B (Blue
Level), or W (White Level), then hit <ENTER>.
3.) Now using the <UP/DOWN> buttons, select the maximum level for each color between
000-255 (000=off), and hit <ENTER> to confirm your choice.
4.) You have now just setup and saved a custom global color calibration setting that you can use
at you convenience. To use your custom setting now (or later), press the <UP/DOWN> buttons
to reach USE, and press <ENTER>. Then choose either YES or NO and press <ENTER>. When
you select YES, it enables this custom color calibration globally, and when choosing NO the
fixture will continue to use the default color calibration settings. Your customized settings will
be saved for later use even after powering off the fixture. It can be altered to your liking at any
time. Just remember to return to this setting to either enable or disable it when needed.
Custom Static Colors & Preset Colors:
Allows the user to create and save up to 10 custom static colors for use in standalone or DMX mode.
Custom Mixing and Preset Mixed Colors
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to STAT and press <ENTER>,
then <UP/DOWN> buttons to select R/G/B/W, and push <ENTER> to confirm your selection.
Then in the same manner, you can select SHUT to add s strobe effect.
2.) You can also select <PRSC> and use the <UP/DOWN> buttons to scroll through and
quickly use any of the fixtures built-in preset colors.
Mix and Save Custom Colors (1-10)
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to CTST and press <ENTER>,
then <UP/DOWN> buttons to select a color bank from CT01-CT10, and push <ENTER> to
confirm your selection.
2.) Now use the <UP/DOWN> buttons to highlight either R (Red Level), G (Green Level), B
(Blue Level), or W (White Level), then hit <ENTER>.
3.) Finally, using the <UP/DOWN> buttons, select the maximum level for each color between
000-255 (000=off), and hit <ENTER> to confirm your choice(s).
4.) These 10 custom colors can be accessed and edited to your liking at any time, and will be
saved even after powering off the fixture.
5.) Your custom static colors are directly accessible from the Effect Channel in DMX mode.
Colorise™ Quadra Manual Rev. A
Page 16
© 2015 Blizzard Lighting, LLC