Table of Contents
Advertisement
5
Programming the
You can program the
can run automatically after turning on the unit. This means you need a DMX Controller
for programming but not for running the stand alone program.
5.1 Engage the Program Mode
Normal - Mode: Receive standard DMX signal.
Receive - Mode: The scanner receives DMX signals for programming and stores
the steps.
Send - Mode: The scanner works stand alone and sends DMX signals to other
scans.
a) Engage at the
Press the Menu key once. P_n_. You are now in the Normal – Mode.
Change with the Cursor key to the Receive – Mode P._r_ or further to the Send
– Mode P._S_
Press the Menu key again to confirm the changes.
b) Engage with a DMX Controller
Look at the channel selection overview table.
5.2 Write a program
You must be in the Receive- or Send – Mode to program the
mode the DMX Channels 13, 14 and 15 are activated.
Procedure:
1) Activate the Receive- or Send - Mode.
2) Set Channel No.13 to "Set DMX-Values" (DMX 16..254).
3) Choose the programstep with DMX Channel No.15.
4) Set your DMX adjustments with the DMX Channels No.1..12.
5) Choose the Next Time or the Audio control with DMX Channel No.14.
6) Save the step with DMX Channel No.13 xx
7) etc.
GLP
German Light Production
J
O
Y
-
3
0
0
J
O
Y
-
3
0
0
J
O
Y
-
3
0
0 in a standalone program within 25 steps. This program
J
O
Y
-
3
0
0
J
O
Y
-
3
0
0
J
O
Y
-
3
0
0
255
(V2.1)
J
O
Y
-
3
0
0
. In this
J
O
Y
-
3
0
0
.
00.
14
Advertisement
Table of Contents
