Display Assembly, Touch Models - HP ProBook 430 G7 Maintenance And Service Manual

Display assembly, touch models

Before disassembling the display assembly, follow these steps:
1. Prepare the computer for disassembly
2. Place the computer in Battery Safe mode
3. Remove the bottom cover
4. Remove the battery
Disassemble the display assembly:
1. Remove the display assembly from the computer:
a. Disconnect the display cable from the system board ZIF connector (1).
b. Disconnect the antennas from the WLAN module (2) (select models only).
c. Disconnect the antennas from the WWAN module (3) (select models only).
d. Remove the four Torx T8 2.5 × 4.0 screws (4) that secure the display assembly to the computer.
e. Rotate the display to open the hinges (5), and then separate the display from the computer (6).
2. Insert a nonconductive, nonmarking plastic tool between the display panel and the display back cover
(enclosure), and then pull the tool around the sides of the panel to separate the display panel from the
enclosure (1).
(Preparation for disassembly on page
(Battery Safe mode on page
(Bottom cover on page
(Battery on page 35).
34).
36).
Component replacement procedures
34).
61