Time Out; File Menu; Run Mode - AMX Novara 1000 Series Operation/Reference Manual

AMX Novara DCS1000 Device Configuration Software

Time Out

A Script can be written to execute if a button press is not detected within a set time period. For example, switching
equipment off that may have been left running overnight.
Three time periods can be set:
1.
From the Ancillary options (in the System window), select Time Out (FIG. 114):
FIG. 114 Ancillary options - Time Out
2.
This invokes the Time Out window (FIG. 115):
FIG. 115 Time Out window
3.
Use the arrows on the Hours and Minutes fields to set a time for Time Period 1.
4.
Write a script, as usual.
When the panel is configured and a button press is not detected within the time period then the script will execute.



File Menu

The file menu gives the option to Save and Open program files.



Run Mode

There are two modes of operation, selectable via the Run Mode menu item:


Changing Run Mode will erase all Manual Run events.
62
A 2nd period can be set to occur after the 1st period has elapsed. Again if a button press has still not occurred
within that time then the 2nd period script will execute.
A 3rd period can be set to occur after the 2nd period has elapsed. If a button press is detected at any time then
the internal clock will be reset back to detect for a button press during the 1st period.
To clear the program for writing new programs click on 'New'
Clicking on 'Print Script' will print out a hard copy of the Script.
Manual Mode – normal configuration mode.
Auto-Run – events in a script will start running 5 seconds after switch on.
Up to 1330 events can be programmed in a script and can be continually looped.
From the Run Mode menu select Auto-Run then Continue.
Write the script then click on Loop if you want the script to continually run.
Novara ControlPads & KeyPads