Control Strings For Axlink; Available Control Strings - AMX Novara 1000 Series Operation/Reference Manual

Control Strings for AxLink

Available Control Strings

The Novara AxLink keypads require the Control Commands to be sent as
SEND_STRING.
Available Control Strings
Command Function
BL=xx
MB=xx
FR=xx
PR=xx
SLnn=a
SLGbbbb=a Set LED Group
SRQ
IRQ
SETHZ
SETVT
Novara ControlPads & KeyPads
Set Backlight level
• xx = 00-99
NOTE: numbers must be listed in format given, with single numbers prefaced with "0".
Set Max Brightness
• xx = 00-99
NOTE: numbers must be listed in format given, with single numbers prefaced with "0".
Set Flash Rate
• xx = 00-99
NOTE: numbers must be listed in format given, with single numbers prefaced with "0".
Set Pulse Rate
• xx = 00-99
• Adjusting the pulse rate sets the rise and fall time within the flash rate, to be effective, both may need to
be adjusted. AMX recommends leaving as default values.
NOTE: numbers must be listed in format given, with single numbers prefaced with "0".
Set LED State
• nn = Button number (01-32), 00 = All
• a = LED state (1 – Low, 2 – High, 3 – Flash, 4 – Off, 5 – Pulse)
• bbbb = 32 bits, 1 bit per LED (1 change, 0 leave)
• a = LED state (1 – Low, 2 – High, 3 – Flash, 4 – Off, 5 – Pulse)
Request Status
• Returns 32 bytes of LED button status (byte 1 = LED 1 etc)
Request Setup Info
• Returns 7 bytes (Byte 1 = Backlight level, 2 = Max brightness level, 3 = Flash rate,
4 = Pulse rate, 5 = orientation, 0=Vertical, 1=Horizontal
• Bytes 6&7 are the firmware version installed where values of 1 and 0 mean firmware version 1.0
Set Horizontal Layout
Set Vertical Layout
Control Strings for AxLink
65