Confirmation Of Indoor Unit No. Position - Toshiba RAV-SM564ATJP-E Service Manual

1
SET CL
Push +
for 4 seconds or more.
2
(← ← ← ← ← Line address)
Using the temperature setup
set to the CODE No.
3
Using timer time
4
SET
Push button. (OK when display goes on.)
5
(← ← ← ← ← Indoor unit address)
Using the temperature setup
6
Using timer time
7
SET
Push button. (OK when display goes on.)
8
(← ← ← ← ← Group address)
Using the temperature setup
9
Using timer time
10
SET
Push button. (OK when display goes on.)
11
TEST
Push button.
Setup completes. (The status returns to the usual stop status.)
10-5. Confirmation of Indoor Unit No. Position
1. To know the indoor unit addresses though position of the indoor unit body is recognized
In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
ON / OFF
Push
2
UNIT LOUVER
Push
Unit No. is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and
indoor unit address.
(When other indoor units are connected to the
identical remote controller (Group control unit), other
unit numbers are also displayed every pushing
UNIT LOUVER
button.
SVM-13072.indb 90 SVM-13072.indb 90
TEST
+ buttons simultaneously
/
/ buttons, set the line address.
/
/ buttons, set 1 to the line address.
/
/ buttons, set
button if the unit stops.
button.
buttons,
buttons, set to the CODE No.
buttons, set to the CODE No.
to Individual, to Master unit, and
– 90 –
FILE NO. SVM-13072
to sub unit.
11/01/13 1:53 PM 11/01/13 1:53 PM