Table of Contents
Advertisement
10-4. Confirmation of indoor unit No. position
1. To know the indoor unit addresses though position of the indoor unit body is recognized
• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
ON / OFF
Push
button if the unit stops.
2
Push UNIT of
UNIT LOUVER
1-1
Unit No.
is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and
indoor unit address.
(When other indoor units are connected to the
identical remote controller (Group control unit), other
unit numbers are also displayed every pushing
UNIT LOUVER
button.
2. To know the position of indoor unit body by address
• To confirm the unit No. in the group control
(Follow to the procedure during operation) (in this procedure, the indoor units in group control stop.)
<Procedure>
The indoor unit numbers in the group control are
successively displayed, and fan, and drain pump of the
corresponding indoor unit are turned on.
(Follow to the procedure during operation)
1
VENT
TEST
Push
and
4 seconds or more.
• Unit No.
is displayed.
• Fans of all the indoor units in the group
control operate.
2
Every pushing UNIT of
in the group control are successively displayed.
• The unit No. displayed at the first time indicates the
master unit address.
• Fan of the selected indoor unit only operate.
3
TEST
Push
button to finish the procedure.
All the indoor units in the group control stop.
button.
buttons simultaneously for
UNIT LOUVER
button, the unit numbers
FILTER
L L
RESET
<Operation procedure>
1
2
END
1
FILTER
L L
RESET
3
<Operation procedure>
1
2
– 87 –
TEMP.
ON / OFF
TIMER SET
FAN
MODE
TIME
SAVE
A A
VENT
TEST
SET
CL
SWING/FIX
UNIT LOUVER
T
TEMP.
ON / OFF
TIMER SET
FAN
MODE
TIME
SAVE
A A
VENT
TEST
SET
CL
SWING/FIX
UNIT LOUVER
T
3
END
1
Operation
2
2
Advertisement
Table of Contents
