Confirmation Of Indoor Unit No. Position - Toshiba RAV-SM564UTP-E Service Manual

9-4. Confirmation of Indoor Unit No. Position
1. To know the indoor unit addresses though position of the indoor unit body is recognized
• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
ON / OFF
Push
2
UNIT LOUVER
Push button.
Unit No. is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and indoor
unit address. (When other indoor units are connected to
the identical remote controller (Group control unit), other
unit numbers are also displayed every pushing
button.
2. To know the position of indoor unit body by address
• To confirm the unit No. in the group control
(Follow to the procedure during operation) (in this procedure, the indoor units in group control stop.)
<Procedure>
The indoor unit numbers in the group control are
successively displayed, and fan, louver, and drain
pump of the corresponding indoor unit are turned on.
(Follow to the procedure during operation)
1
VENT
Push and
for 4 seconds or more.
• Unit No.
• Fans and louvers of all the indoor units in the
group control operate.
2
Every pushing
numbers in the group control are
successively displayed.
• The unit No. displayed at the first time indicates
the header unit address.
• Fan and louver of the selected indoor unit only
operate.
3
TEST
Push button to finish the procedure.
All the indoor units in the group control stop.
SVM-13010_051-106.indd 87 SVM-13010_051-106.indd 87
button if the unit stops.
TEST
buttons simultaneously
is displayed.
UNIT LOUVER
button, the unit
TEMP.
TIMER SET
FILTER L L
UNIT LOUVER
RESET TEST SET
<Operation procedure>
1 2
END
TEMP.
1
FILTER L L
RESET TEST
3
<Operation procedure>
1 2 3
– 87 –
FILE NO. SVM-13010
ON / OFF
1
Operation
FAN MODE
TIME SAVE A A VENT
CL SWING/FIX UNIT LOUVER T
2
ON / OFF
TIMER SET FAN MODE
TIME SAVE A A VENT
SET CL SWING/FIX UNIT LOUVER T
END
2
2/1/13 2:49 PM 2/1/13 2:49 PM