Replacement Of The Service P.c. Board - Toshiba RAV-SM564ATJP-E Service Manual

11. REPLACEMENT OF THE SERVICE P.C. BOARD

11-1-1. RAV-SM564AT
Don't open the inverter cover before 1 minute after power has been turned off because an electric shock may be occurred.
Replacement steps:
1
Jumper wires "J800∼J803"
Cut the jumper wires of the service board, as instructed in the table below.
The jumper setting of J800∼J803 differs from original supplied P.C.Board, therefore be sure to configure the jumpers
as in the table below. If the model is not specified, the equipment will not operate.
Model name
Service P.C. Board
RAV-SM564AT*P*
RAV-SM804AT*P*
2
Jumper wires "J804∼J805"
Set the jumper wires J804∼J805 of the service board to the same as settings of the P.C.board before replacement.
SVM-13072.indb 92 SVM-13072.indb 92
P , SM804AT P (MCC-1645)
* * * *
! WARNING
J800 J801 J802
○ ○ ○
× ○ ○
○ × ○
– 92 –
FILE NO. SVM-13072
Jumper wires
J803
： Connected
○
○
×：Cut
○
○
11/01/13 1:53 PM 11/01/13 1:53 PM