Hot-Plug Scsi Hard Drives - HP ProLiant BL20p Generation 2 Maintenance And Service Manual

Hot-Plug SCSI Hard Drives

To assess hard drive status, observe the hot-plug SCSI hard drive status LEDs. For a detailed
explanation of these LEDs, refer to Chapter 4, "Connectors, LEDs, and Switches."
IMPORTANT: It is not necessary to power down the server blade before removing or replacing a
hot-plug SCSI hard drive.
To remove a hot-plug SCSI hard drive:
1. Press the port-colored release button (1).
2. Open the ejector lever (2).
3. Slide the drive out of the drive cage (3).
Figure 2-5: Removing a hot-plug SCSI hard drive
To replace a hot-plug SCSI hard drive:
1. Slide the drive into the cage until it is fully seated.
2. Close the lever, locking the drive into place.
HP ProLiant BL20p Generation 2 Server Blade Maintenance and Service Guide
HP CONFIDENTIAL Codename: Reppin Part Number: 316078-005 Last Saved On: 2/23/04 10:31 AM
CAUTION: Refer to the HP ProLiant Servers Troubleshooting Guide before removing a hard
drive.
CAUTION: Always populate hard drive bays with either a hot-plug SCSI hard drive or hard
drive blank. Operating the server blade without a hot-plug SCSI hard drive or hard drive blank
results in improper airflow and improper cooling that can lead to thermal damage.
Removal and Replacement Procedures
2-9