Table of Contents
Advertisement
Fan Assembly
To remove the fan assembly:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blad e Preparation" section in this chapter.
2. Remove the access panel. Refer to the " Access Panel" section in this chapter.
3. Disconnect the fan assembly cables from the system board.
IMPORTANT: Be sure to connect the cables to the same connectors when replacing the fan assembly.
Figure 2-16: Disconnecting fan cables
HP ProLiant BL20p Generation 2 Server Blade Maintenance and Service Guide
HP CONFIDENTIAL Codename: Reppin Part Number: 316078-005 Last Saved On: 2/23/04 10:31 AM
Removal and Replacement Procedures
2-17
Advertisement
Table of Contents
