Table of Contents
Advertisement
Removal and Replacement Procedures
NIC Modules
To remove the standard NIC module:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blad e Preparation" section in this chapter.
2. Remove the access panel. Refer to the " Access Panel" section in this chapter.
3. Remove the standard NIC module:
a. Turn the quarter-turn standoff latches on the Smart Array 5i Plus Controller module
b. Lift the Smart Array 5i Plus Controller module from the system board (2).
c. Turn the quarter-turn standoff latches on the FC mezzanine card counter-clockwise
d. Lift the FC mezzanine card away from the system board (4).
Figure 2-19: Removing the NIC module
Reverse steps 1 through 3d to replace a NIC module.
2-20
HP CONFIDENTIAL Codename: Reppin Part Number: 316078-005 Last Saved On: 2/23/04 10:31 AM
counter clockwise (1).
(3).
CAUTION: Lifting one edge of the module at a time may damage the connectors. Be sure to
lift the module straight up.
HP ProLiant BL20p Generation 2 Server Blade Maintenance and Service Guide
Advertisement
Table of Contents
