Dimms - HP ProLiant BL20p Generation 2 Maintenance And Service Manual

Removal and Replacement Procedures

DIMMs

To remove a DIMM:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blad e Preparation" section in this chapter.
2. Remove the access panel. Refer to the " Access Panel" section in this chapter.
NOTE: The server blade ships with at least two DIMMs installed in slots 1A and 2A.
3. Open the DIMM slot latches (1).
4. Remove the DIMM from the slot (2).
Figure 2-6: Removing a DIMM
IMPORTANT: Always install DIMMs in identical pairs.
IMPORTANT: DIMMs do not seat fully if turned the wrong way.
Reverse steps 1 through 4 to replace a DIMM.
2-10
HP CONFIDENTIAL Codename: Reppin Part Number: 316078-005 Last Saved On: 2/23/04 10:31 AM
CAUTION: For proper DIMM configuration, refer to the setup and installation guide.
CAUTION: Use only HP DIMMs. DIMMs from other sources may adversely affect data
integrity.
HP ProLiant BL20p Generation 2 Server Blade Maintenance and Service Guide