Table of Contents
Advertisement
Access Panel
To remove the access panel:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blad e Preparation" section in this chapter.
2. Loosen the thumbscrew (1).
3. Press down on the thumb indentations, slide the access panel toward the rear of the unit
about 1.25 cm (0.5 in), and lift to remove the panel (2).
Figure 2-3: Removing the server blade access panel
Reverse steps 1 through 3 to replace the access panel.
HP ProLiant BL20p Generation 2 Server Blade Maintenance and Service Guide
HP CONFIDENTIAL Codename: Reppin Part Number: 316078-005 Last Saved On: 2/23/04 10:31 AM
Removal and Replacement Procedures
2-7
Advertisement
Table of Contents
